Help Centre
Cone and paste troubleshooting
Questions in this topic
Why is the paste too thick to flow?
The paste may still be too cold, may not have been redistributed after thawing, or may be meeting a blocked or very fine tip. Let the exact product finish thawing naturally, massage… Read answerWhy is it watery or too thin?
Temperature changes can separate liquid from paste, while a damaged batch or an unsuitable homemade ratio can also make it runny. Keep a purchased cone closed, massage it gently and test a… Read answerWhy does the line break instead of flowing continuously?
Broken lines commonly come from an air pocket, a partial blockage, paste that is too cold or uneven pressure. Gently work the paste towards the tip, expel a tiny test amount onto… Read answerWhy is the paste spreading after application?
The paste may be too warm or thin, the opening may be larger than expected, or the skin may have moisture, lotion or oil on it. Let a purchased cone settle at… Read answerWhy is paste leaking from the back or seam?
The closure may have loosened, the wrapper may be split, or pressure from squeezing or warming may have opened the seam. Stop applying it to skin, place it on a clean disposable… Read answerWhy is liquid or oil separating from the paste?
Paste ingredients can redistribute during freezing, thawing and transport, so a little separation may occur without identifying a fault. Keep the package closed, gently work the contents together and test its consistency… Read answerWhy is the paste curling as it exits the cone?
Curling usually means the paste is catching at the tip, the opening is uneven, or the cone is being held too far from the surface. Test the flow, wipe the outside of… Read answerWhy are air bubbles causing gaps and blobs?
Air can become trapped during filling or as paste is pushed unevenly towards the tip. With the cone closed, massage it gently from the broad end towards the tip, then expel a… Read answerWhy does paste crack and fall off too early?
Thin lines, movement, cold or very dry air can make paste lose flexibility and flake before you intend it to. Let the design become touch-dry without bending the area, then use only… Read answerWhy is it taking too long to dry?
Thick application, high humidity, cool conditions or paste that is too wet can lengthen drying time. Our Fresh Natural Henna Paste usually takes about 20 minutes to dry, but this is a… Read answerWhy did tape or wrapping smudge the design?
The paste was probably not fully touch-dry, the covering pressed against raised lines, or trapped warmth and moisture softened it again. Do not tape tightly over wet paste. Let the exact product… Read answerPersonal support
Still need help?
Get an instant answer from the assistant, or speak with our team for personal help.